Comfort Glow CCL3018N Owner's Operation And Installation Manual page 16

INSTALLATION
16
Installing Logs (Cont.)
INSTALLATION
Continued
Single Burner Seasonal Oak Models
WARNING: Failure to position the parts in accor-
dance with these diagrams or failure to use only parts
specifically approved with this heater may result in
property damage or personal injury.
The Seasonal Oak Log Set is a reversible log set. This means that the
two bottom logs may be turned to face either direction. The top log,
however, must remain in the same position. Do not modify logs.
Only use logs supplied with heater.
1. Place the back log onto the back of the base assembly. Make
sure log sits forward against the two posts in front of log (see
Figure 35). This log may be turned to face either direction.
2. Place the front log onto grate on front of base assembly. The
log will fit down between grate fingers and posts on front of
base assembly (see Figure 36). This log may be turned to face
either direction.
3. Place the crossover log on top of the back log and front log
making sure pins are inserted into holes on top of logs 1 and 2.
This log must be placed as shown in the Figure 37 or the pins
will not seat into holes.
4. Add lava rock around base of heater if desired. Do not put lava
rock on logs or burner.
Post
Base
Assembly
Figure 35 - Installing Back Log
For more information, visit www.desatech.com
For more information, visit www.desatech.com
Figure 36 - Installing Front Log
Back Log
Post
Figure 37 - Installing Crossover Log
Post
Grate
Fingers
Crossover Log
Hole in
Front Log
Front Log
Base
Assembly
Post
Hole in Back Log
107123-01E