Advertisement
Advertisement
Table of Contents
Related Manuals for Pro's Pro TX 500N
Summarization of Contents
Unpacking and Inspection
Inspection and Contents Check
Verify machine condition and ensure all parcel contents are present upon delivery.
Operating Instructions
Initial Setup and Power On
Place machine, switch on, and confirm LED display and tension scale selection.
Tension Selection and Machine Operation
Use the knob to select tension; understand the 3 machine positions for operation.
Finishing Stringing Operations
Release string if needed, turn off machine, and reset tension for storage.
Fixing of the Racket
Racket Placement and Securing
Position racket, use side supports, and tighten mounting stocks carefully to avoid deformation.
Stringing System Setup
Loading String into Tension System
Route string over reels, into slot, hold down, and press button 1 to start tensioning.
Swivel Clamp Adjustment
Adjusting Holding Pressure
Insert Allen wrench into base side hole to slightly adjust clockwise for optimal pressure.
Maintenance
General Care and Storage
Keep machine dry, safe, and away from dust, grease, moisture, and heat.
Cleaning Procedures
Use soft cloth or brush for dust; use emery cloth for wax buildup on clamps.
Lubrication and Maintenance Warnings
Do not lubricate turntable tracks or use penetrating oils.
Clamp Checks and Tension Reset
Check clamps for proper grip and reset tension to 10kg after stringing.
Troubleshooting
Power Issues
Address problems with the power light or electronic components not functioning.
String Clamp Not Holding
Solutions for string clamps failing to grip the string securely.
String Slipping Through Gripper
Troubleshoot issues where the string slides out of the string gripper.
Clamp Movement Issues
Resolve problems with clamps not moving smoothly or not fixing properly.
Incorrect Tension Pulling
Diagnose and correct inaccurate tension application during stringing.
Calibration
Calibration Procedure
Step-by-step guide to calibrate the machine using a tension calibrator.
Need help?
Do you have a question about the TX 500N and is the answer not in the manual?
Questions and answers