Air Filter - ViewSonic PJ452 - LCD XGA Projector-4.9LBS User Manual

Air filter

WARNING ►Do not replace the air filter during use or immediately after use.
Handling while the projector is in a high temperature could cause a burn and/or
malfunction to the projector. Before operating, make sure that the power switch is off,
that the power cord is not plugged in, and that the projector is cool adequately.
►Use only the air filter of the specified type. Do not use the projector with the air filter
and filter cover removed.
►Avoid wetting the projector or inserting liquids in the projector. It could result in a
fire, an electric shock, and and/or malfunction to the projector.
CAUTION ►Please replace the air filter when it is damaged or too soiled, and also
when you replace the lamp.
When the indicators or a message prompts you to clean the air filter, clean the air filter as
soon as possible. If the air filter becomes clogged by dust or the like, internal
temperatures rise and the power may be automatically turned off for malfunction
prevention.
1. Disconnect all the connectors and adapters that were connected to the projector's ports.
Then slowly turn the projector so that the lens-side is facing up. Please be careful for a
projector not to fall. While the projector is placed lens-side up, hold the projector.
2. Remove the filter cover and the air filter. Hold the knobs while pulling out it.
Usual filter cover
Filter cover for bottom-up use
3. Apply a vacuum cleaner to the vent of the projector for the air filter. And then slowly turn the
projector bottom up.
ViewSonic PJ452
Filter cover's knobs
Filter cover's knobs
Air filter's knob
43