Using The Macro Function - Denon RC-7000CI Owner's Manual

LCD button
LCDボタン
BACK
DEVICE
RC SETUP
About the button names in these explanations
[ ] : LCD buttons for selection items
Button name only:
Indicates a button on the remote control unit

7
Place the remote control units with their
signal transmitters facing each other, press
NEXT
, then immediately press the button
LCD button
LCDボタン
on the remote control unit you want to
register.
NEXT
8
To register other buttons, press
b Repeat steps 6 to 8.
9
[EXIT]
Press
b Press [EDIT] if you want to change the button name.
Perform the procedure at "Changing the button name"
(v page 18) starting from step 7.
NOTE
The learning function may not work for some remote control
units, and sometimes a device may not operate properly even
if its remote control signals have been learned. In this case,
use the remote control unit included with the device.
"Success!" is displayed if the
code was learned successfully.
NEXT
.
to exit the learning mode.

Using the Macro function

This function allows you to register a series of
operations at a single button.
With this function you can for example turn on the
amplifier, select the input source, turn on the TV's
power, turn on the source device's (equipment) power
and set the play mode all by pressing a single button.
1
RC SETUP
Press for 3 seconds.
The "PROGRAM DEVICE" menu is displayed.
2
[MACROS]
Press .
3
[ADD/REDO]
Press .
4
NEXT
Press twice.
5
At the "Assign Macro" screen, press the
LCD button
for the device (equipment) for
which you want to register the macro.
6
Press the button at which you want to
register the macro.
b Macros can be registered at buttons other than NEXT,
BACK and DEVICE.
7
NEXT
Press to register the next signal.
b Press DEVICE to select the device.
b Repeat steps 5 to 6.