Picture Menu; Picture Mode; Contrast; Brightness - Panasonic PT-D5000ELS Functional Instructions

PICTURE menu

Remote control
See "Navigating through the menu" on page 15.
See "Main menu and Sub-menu" on page 12.

PICTURE MODE

Depending on the projection environment, you can use these
preset parameter settings to optimise image projection. Press
I H to cycle through the options.
STANDARD
CINEMA
NATURAL
DYNAMIC
GRAPHIC
NOTE:
• Factory default is STANDARD for moving images and
GRAPHIC for RGB system.

CONTRAST

You can adjust the contrast of the projected image. Adjust the
BRIGHTNESS in advance if necessary.
Call up the bar scale by pressing I, H or the ENTER button,
and press I H to adjust the value.
I
H
Setting range: -31 to +31

BRIGHTNESS

You can adjust the brightness of the projected image. Call up
the bar scale by pressing I, H or the ENTER button, and
press I H to adjust the value.
I
H
Setting range: -31 to +31
E
NGLISH - 16
Setting for a general image
Setting for a cinema type movie
Reproduces the original colour of the
image
Bright and sharp setting
Setting for image from computers
Lower
Higher
Darker
Brighter

COLOR

You can adjust the colour saturation of the projected image.
Call up the bar scale by pressing I, H or the ENTER button,
and press I H to adjust the value.
Lighter
I
Darker
H
Setting range: -31 to +31

TINT

You can adjust the skin tone in the projected image. Call up the
bar scale by pressing I, H or the ENTER button, and press
I H to adjust the value.
More reddish
I
More greenish
H
Setting range: -31 to +31

COLOR TEMPERATURE

You can adjust the white balance of the projected image.
Select the required option and press I, H or the ENTER
button to call up the bar scale.
DEFAULT Balanced white
USER More detailed adjustment
MIDDLE More reddish
HIGH More bluish
Adjusting more detailed white balance
You can adjust white balance of RGB individually in high
and low level.
1. Select USER and press the ENTER button.
2. Select WHITE BALANCE HIGH or WHITE BALANCE
LOW, and call up the scale bars by pressing I, H or
the ENTER button.
3. Press I H to adjust the value of each colour.
Setting range
WHITE BALANCE HIGH: 0 to 255 (Default: 255)
WHITE BALANCE LOW: 0 to 63 (Default: 32)
NOTE:
• With excessive unbalanced adjustment, such as extremely
high with extremely low setting, all the colours may be
displayed abnormally. Press the DEFAULT button to reset the
selected item to the default setting.
• Adjust COLOR TEMPERATURE with signal image. Internal
test pattern is not for COLOR TEMPERATURE adjustment.