Projector Setup Menu; Projector Id; Installation; High Altitude Mode - Panasonic PT-D5000ELS Functional Instructions

PROJECTOR SETUP menu

Remote control
See "Navigating through the menu" on page 15.
See "Main menu and Sub-menu" on page 12.

PROJECTOR ID

The projector has an ID number setting function that helps the
user to control multiple projectors either simultaneously or
separately with a single remote control. Press I H to cycle
through the options.
ALL
1 - 64
NOTE:
• See "Remote control ID" in the operating instructions booklet
that is provided with the projector.

INSTALLATION

When installing the projector, select the projection method
according to the projector position. Press I H to cycle through
the options.
FRONT/FLOOR
FRONT/CEILING
REAR/FLOOR
REAR/CEILING
NOTE:
• See "Projection method" in the operating instructions booklet
that is provided with the projector.
E
NGLISH - 28
Available to control from any ID
numbered remote control or computer.
Available to control from the same ID
numbered remote control.
Setting on a desk/floor and projecting
from front
Mounting on the ceiling and projecting
from front
Setting on a desk/floor and projecting
from rear
Mounting on the ceiling and projecting
from rear

HIGH ALTITUDE MODE

If you use the projector at high elevation, the HIGH ALTITUDE
MODE setting needs to be ON to set the fan speed high. Press
I H to select the required option.
OFF The fan speed is low.
ON The fan speed is high.
NOTE:
• At 1 400 - 2 700 m (4 593 - 8 858 ft) sea level, the setting must
be ON.
• The loudness of fan noise depends on the HIGH ALTITUDE
MODE setting.

COOLING CONDITION

You can control the fan speed for projecting angle. Press I H
to cycle through the options.
VERTICAL UP
SETTING
FLOOR
SETTING
VERTICAL DOWN
SETTING
NOTE:
• When the projector is angled, COOLING CONDITION setting
must be set correctly. Failure to observe this may result in
malfunctions, or the life of the lamp or the other components
may be shortened.
CEILING
SETTING