HP P5389A - Intel Pentium III-S 1.4 GHz Processor Upgrade Installation Manual page 4

C. Click OK. Click Next.
12. At the boot loader configuration screen, you need to accomplish the following
tasks:
-- Choose "change boot loader" to change to LILO or NO BOOT LOADER,
otherwise, leave the default of GRUB.
-- Verify that "Red Hat Linux" is selected as the default operating system to boot.
-- Choose whether to create a boot loader password or not. (The default is none).
-- Choose "advanced boot loader options" to choose where to install boot loader to:
MBR or the first sector of the boot partition.
Click Next.
13. Configure your network interfaces. You can use DHCP (recommended) or static IP to
configure the network interfaces. Click Next.
14. At the Firewall Configuration screen, configure the firewall to suit your
requirements. Click Next.
15. At the Language Selection screen, select all the languages you would like support
for. Click Next.
16. Select the appropriate timezone for your area. Click Next.
17. Enter the root password. On the next line, reconfirm the password. The password will
not get displayed. Click Next.
18. Create any additional accounts required by clicking Add.
19. Set the Authentication schemes that apply to your network. Click Next.
20. At the Package group selection screen, select the software package that suits your
need. You can customize the preset packages by clicking on Select individual
packages. Click Next.
21. This is the last step before the install begins. If you would like to make a last minute
change, click on Back, otherwise click Next.
22. The package installation process will now begin. The projected time for completion
will be shown.
23. (Optional) After the package installation process, if you have installed the X Window
System, you will have to configure your video hardware.
4