HP P5389A - Intel Pentium III-S 1.4 GHz Processor Upgrade Installation Manual page 3

NOTE: Click on the other drives to deselect them.
Additional Size Options:
You will have the opportunity to choose the following additional options:
- Fixed Size (MB)
- Fill all space up to (MB)
- Fill to maximum allowable size
- Leave at fixed size
- Force to be a primary partition
- Check for Bad Blocks
Leave the above items unchecked, unless you want to check for bad blocks. If you
choose this option, be aware that the check will take a considerable amount of
time, depending on drive size.
D. Click OK.
10. Create a swap partition.
A. Click New.
B. Set the parameters as follows:
Mount point: <not applicable>
Partition type: swap
NOTE: Click on the other drives to deselect them.
C. Click OK.
11. Create a root partition.
A. Click New.
B. Set the parameters as follows:
Mount point: /
NOTE: If you will be choosing to install ALL packages, it will take 4,680Mb, so
you will need to increase the size of the / partition to at least that amount. If you
wish, you may choose to allow the partition to fill to a particular size (which you
specify), or to the maximum allowable size.
Partition type: Ext3
NOTE: Click on the other drives to deselect them.
Allowable drives: sda
Size: 2048
Allowable drives: sda
3
Size: 256