HP P5389A - Intel Pentium III-S 1.4 GHz Processor Upgrade Maintenance Manual page 63

Chapter 5
Code Description
0306 Flexible disk drive controller
boot error
0307 Flexible disk drive controller
resource conflict
0400 CD-ROM boot error
0401 CD-ROM drive not responding
Problem/Solution
POST has detected a general failure on the integrated flexible disk
controller.
To verify this:
1. Restart your HP Server.
2. If the error persists, your system board may need to be replaced.
Contact your service representative.
POST has detected an address space or IRQ resources conflict
between the integrated flexible disk controller and an accessory
board.
To correct this:
1. If the integrated flexible disk controller is not needed, run the
Setup Utility and disable the flexible disk controller.
2. If the integrated flexible disk controller is needed, the accessory
board's IRQ and address space must be reconfigured to use other
free resources. Refer to the accessory board installation manual
for information.
POST has detected the CD-ROM drive has reported an error during
its self-test.
To correct this:
1. If a CD-ROM disk is present, verify it is correctly inserted.
2. Verify the CD-ROM drive door or tray has not been opened or
closed during the self-test.
3. Verify all data cables and power cables are firmly connected.
4. If the problem persists, your CD-ROM drive may need to be
replaced. Contact your service representative.
POST has detected the CD-ROM drive is not responding, but is
configured in the Setup Utility.
To correct this:
1. If the CD-ROM drive has just been removed, press F4 to
automatically validate the change.
2. Verify all data cables and power cables are firmly connected.
3. If the cable is damaged, connect the CD-ROM to another cable,
if available. The Setup Utility and the 32-bit disk access driver
may need to be modified accordingly.
4. If the problem persists, your CD-ROM drive may need to be
replaced. Contact your service representative.
Error Messages
57