Brother HL-2170W Network User's Manual page 72

Note
• If you want to setup more than WEP key1, click Advanced.
• If you do not know the Authentication or Encryption settings for your network, contact your network
administrator.
• If the Authentication Method is set to Open System and the Encryption Mode is set to WEP, an error
indication will NOT appear if the Network key is incorrect.
o
Click Next. The settings will be sent to your printer. The settings will remain unchanged if you click
Cancel.
Note
If you want to manually enter the IP address settings of your printer, click Change IP Address and enter
the necessary IP address settings for your network.
p
To communicate with the configured wireless device, you must configure your computer to use the same
wireless settings. Manually change the wireless settings on your computer to match the printer's wireless
settings shown on this screen. Check the box after these settings, and then click Next or Finish.
(The settings shown on this screen are for example only. Your settings will not be the same.)
You have completed the wireless setup. If you chose to install the printer driver in step e, Go
to Installing the printer driver on page 66.
Wireless configuration for Macintosh
®
using the Brother installer application (For HL-2170W)
5
65