7) Attach the cord holders [1] to the holes of the top stand stay. Bring the power cord of the right media take-up unit to the back of the printer and pass the cord

through the cord holders. After passing the cord behind the holders, plug the cord into the power supply connector on the back of the printer.

When plugging in the power cord, be careful about the positions of the prongs. It may damage the cord or connector if you force the cord into the connector.

8) Load the left side of the media take-up spool on the media take-up unit so that the gear [1] on the right side of the media take-up spool meshes with the gear [2]

of the right media take-up unit.

3-16

F-3-33

[1]

F-3-34

Table of Contents