15) Remove the cutter unit, and lay the caterpillar of the ink tube unit on its side, and then remove the carriage from the right side of the printer.

- To remove the carriage unit, pull it out of position keeping the carriage unit level with care not to harm the linear scale. Flaws on the linear scale could result in

malfunctioning.

- After detaching the joint of the ink tube unit, the joint might become easy to come off by the ink that has adhered to it.

In that case, please wash the joint by alcohol and remove the adhering ink.

b) Mounting the carriage belt

To install the carriage belt, put in the point of the belt to the interior of the groove [1], and have all the cogs of carriage belt [3] engaged with belt stopper [2].

c) Note on replacing the carriage unit and the multi sensor

[5]

[3]

[4]

[6]

F-4-32

F-4-33

[1]

[3]

[2]

F-4-34

[2]