Film Advance; Switching Camera On And Off; Single Frames; Continuous Shooting - Rollei ROLLEIFLEX 6008 AF Manual

..............................................................................
Switching the camera on and off
With its master switch 1 set to "off", the
camera circuits are dead, and the camera
cannot be inadvertently activated by oper-
ating one of its controls.
After setting the camera to one of the
fi lm-advance modes "S" (single frames),
"C" (continuous shooting) or "S±" (brack-
eting), it can be activated with the aid of
the memo button, one of the shutter but-
tons, the stop-down button or the mirror-
lockup button. As long as the camera is
inactive, the display will remain blank.
In its default setting (that can be changed
with MasterWare), the camera remains
active for 40 seconds. The use of any of its
controls will extend this period by another
40 seconds. In the multi-spot mode and
when the memo button is locked in, the
camera will remain active for an additional
four minutes.
..............................................................................
1
31

Single frames

With the master switch set to "S", a single
frame will be exposed whenever the shut-
ter release is pressed. For another expo-
sure, fi rst release the button, then press it
again.

Continuous shooting

With the master switch set to "C",
the camera will expose one frame after
another for as long as the shutter release
is kept depressed. The maximum shooting
speed is about two frames per second (fps)
at normal temperature (20°C), with a full
battery and at shutter speeds faster than
1/250 s.

FILM ADVANCE

35