Table of Contents
Advertisement
ASSEMBLY
JACKSHAFT BEARING SUPPORT ASSEMBLY
Attach Carrier Mount Weldment (3) to deck with bolt 1/2" x 1-1/4" (12) Lockwasher (21) and Flatwasher (16) for
the front two holes and use Bolt 1/2" x 1-1/2" (22) and Lockwasher (21) for the rear. Then attach Bearing
Assembly (27) to Carrier Mount Weldment (3) with Bolt (10) and Locknut (11). Insert the splined end of
Jackshaft (6) into the Bearing Support. (Figure Asm-R-0301)
RX96 03/09
Assembly Section 3-11
© 2009 Alamo Group Inc.
Advertisement
Table of Contents
