Table of Contents
Advertisement
Needle Rollers have
brinelled into Cup and Cross
Shaft or Tube Twisted
Toke broken at Ear Tip
Slip Clutch slipping
excessively
Oil blowing out Vent Plug
Driveline Integral Shields
rattling or not turning freely
RX96 03/09
© 2009 Alamo Group Inc.
OPERATION
Load too high for joint.
Over-loaded.
Over-loaded.
Excessive load.
Springs weak.
Improper adjustment.
Too much power for
Slip Clutch.
Friction Facings worn.
Oil on Facings.
Friction Facings glazed.
Flat bottomed Vent Plug
or shallow cavity Plug.
Oil level too high.
Integral Shields deformed.
Nylon Bearing worn.
Operation Section 4-47
Check for small joint angles.
Use protective device.
Check joint angles and phasing.
Replace part and then slow down or
or raise Mower. Use protective device.
Replace part.
Reduce speed and/or raise cutter.
Replace Springs.
Re-adjust Slip Clutch
Reduce ground speed and
material intake.
Replace Facings.
Replace Facings.
Clean with emery cloth.
Replace with proper Vent Plug.
Cavity in Oil Plug should be
approximately 5/8".
Lower oil level to Plug.
Replace Shield.
Replace Nylon Bearing.
Advertisement
Table of Contents
