Table of Contents
Advertisement
ASSEMBLY
CONTROL RODS - PULL TYPE
Attach the two level-lift control rods to the lower lugs on tongue and to lugs on the rear axle tube using pins,
washers and cotter pins. Note: The adjusting nuts on control rods should be to rear of machine and should
always be adjusted with equal tension on both rods. Figure Asm-R-0289 & Asm-R-0290.
DRIVELINE CLAMP CONE YOKE
Loosen the yoke clamp cone with a 11/16" (17mm)
wrench and remove the cone from yoke. Slide yoke
onto the shaft and align hole for clamping cone with
annular groove of gearbox shaft. Reinstall cone and
tighten (75 lb-ft torque). Push and pull the driveline
to ensure it is securely attached to the shaft.
Regularly check the driveline yoke to ensure a tight
connection. To remove the yoke, remove the
connecting cone and pull yoke off the shaft. If the
cone cannot be easily removed by hand, drive it out
from the other side using a hammer and punch.
NOTE: The clamping cone is serviced only as a
complete assembly. Do not attempt to disassemble
the clamping cone.
WHEELS
Install the Wheels on the Wheel Hubs.
Note: If Laminated Tires are used, place the flat
side of the Lug Nut against the Wheel.
Note: the direction of travel and curvature of rubber
segments in tire and install as shown in FIGURE
Asm-R-0127.
RX96 03/09
Assembly Section 3-6
© 2009 Alamo Group Inc.
Advertisement
Table of Contents
