Setting The Auto Surround Mode - Denon AVR-1905 Operating Instructions Manual

ENGLISH

Setting the Auto Surround Mode

For the three kinds of input signals as shown below, the surround mode played the last is stored in the memory. At next time it the same signal
inputs, the memorized surround mode is automatically selected and the signal is played.
Note that the surround mode setting is also stored separately for the different input function.
SIGNAL
q
Analog and PCM 2-channel signals
w
2-channel signals of Dolby Digital, DTS or other multichannel format
e
Multichannel signals of Dolby Digital, DTS or other multichannel format
1
2
Setting the Ext. In SW Level
Set the playback level of the analog input signal connected to the Ext. In terminal.
1
2
28
Select "ON" if you want to use the auto surround mode, "OFF" if
you do not want to use it.
24 AUTOSURR. ON
Press the ENTER or (down) button to switch the Ext. In SW Level setting.
Select desired setting.
• Select according to the specifications of the player being used.
Also refer to the player's operating instructions.
• +15dB (default) recommended. (0, +5, 10 and +15 can be
selected.)
25 EXT.IN SW+15
Press the ENTER or (down) button to switch the Power Amp Assignment setting.
Default Auto Surround Mode
STEREO
II
Dolby PL x Cinema
Dolby or DTS Surround