Advertisement
Available languages
Available languages
Step 4: Install software and register your modem.
Eject and re-insert the Installation CD-ROM. The installation utility should start
automatically. The Setup Wizard on the CD-ROM guides you through installing
the program group (including Internet Call Notification, ControlCenter, and
optional voice faxmodem software) and registering your modem.
NOTE: If the Installation CD-ROM interface does not run automatically,
click Windows Start and then click Run. In the "Run" dialogue box, type
D:\setup.exe. If your CD-ROM drive uses a different letter, type that
letter in place of "D."
NOTE: If you would like to use the voice functionality of this modem, you
must install the voice software. This software can be found on the
Installation CD-ROM in the Software section.
Register your modem.
•
At the Installation CD-ROM interface, click the Support link.
•
Follow the on-screen instructions to register your modem and to
view the warranty information. If the Installation CD-ROM interface
does not run automatically, click Windows Start and
then click Run. In the "Run" dialog box, type D:\setup.exe. If
your CD-ROM drive uses a different letter, type that letter in
place of "D."
•
You can also register your modem online by visiting
http://www.usr.com/productreg
Troubleshooting
Having trouble with your modem? Try these basic troubleshooting
steps first.
1) Is your phone cord properly connected? The phone cord should be plugged
into the jack on the modem and into the wall phone jack. Use the phone cord
included in your modem's box. If there was an adapter included with your
modem, attach that to the phone cord before inserting it into the wall jack.
2) Is your modem properly installed in your computer? Refer to the "Verify that
the modem is properly installed" section of this guide for possible solutions
based on your particular operating system.
7
Advertisement
