Table of Contents
Advertisement
Table 4-1. Voice/Data Switch Commands.
S32
Value
Voice/Data Switch Function
0
Disabled
1
Voice/Data Originate Mode
2
Voice/Data Answer Mode
3
Redial Last Number
4
Dial Number Stored at position 0
5
Auto Answer On/Off Toggle
6
Reset Modem
7
Initiate Remote Digital Loopback
8
Busy Out the Phone Line Toggle
9*
Execute Stored Command
* The modem is shipped from the factory set at S32=9. If a command string has
been stored (&ZC= s ), the Courier sends the stored command string when you
push the Voice/Data switch. If no command string is stored, the Courier still
reports that S32=9, but actually behaves as if it is set to S32=1, Originate mode.
You can program the voice/data switch to execute a stored
command string when pressed. The following example assigns a
command string that displays the link diagnostics screen when
you press the voice/data switch.
AT&ZC=I6 <Enter>
Set the voice/data switch function to execute stored command
string by setting Register S32 to 9 with the following command:
ATS32=9 <Enter>
Note that you can reset the voice/data switch at any time to one
of the other available functions. Additionally, you can overwrite
the stored command string with a new one at any time.
Once you've stored your command string and set Register S32,
press the Voice/Data switch whenever you want the Courier to
send the command string.
Related Command
_
ATD (Chapter 3)
ATA (Chapter 3)
ATDL (Chapter 3)
ATDS0 (Chapter 3)
ATS0=0 or 1 (Chapter 3)
ATZ (Chapter 4)
AT&T6, S16=8 (Chapter 15)
_
AT&ZC= s (Chapter 4)
Other Features
4-5
Advertisement
Table of Contents
