US Robotics 002805-00 Getting Started page 18

Table 2-1. DIP Switch Settings.
DIP Factory
Switch Setting
1 OFF
2 OFF
3 ON
4 OFF
5 ON
6 OFF
7 OFF
8 ON
9 OFF
10 OFF
IMPORTANT: When you power ON or reset the Courier, the
DIP switch settings override the settings you may have made
previously using AT commands.
If you change the DIP switch settings while the Courier is
powered ON, you can avoid powering the Courier off to make
the new settings take effect. Just send the Courier the ATZ
command.
1
For more information, refer to the indicated chapter in the Courier Modems
Command Reference.
Setting Effect
OFF DTR normal
ON Ignore DTR
OFF Verbal result codes
ON Numeric result codes
OFF Suppress result codes
ON Display result codes
OFF Echo offline commands
ON Don't echo offline commands
OFF Auto-answer
ON Don't auto-answer
OFF Normal Carrier Detect
ON Carrier Detect always on
OFF Display all result codes
ON Display result codes only when
originating calls
OFF Ignore AT commands (dumb mode)
ON Act on AT commands (smart mode)
OFF Disconnect on +++
ON Don't disconnect on +++
OFF Load the configuration that is stored in
non-volatile memory (NVRAM)*
ON Load the &F0 configuration from
read-only memory (ROM)*
For
More
1
Info
Ch 6
Ch 5
Ch 5
Ch 2
Ch 3
Ch 6
Ch 5
Ch 1
Ch 2
Ch 4
Installing the Courier 2-5