Alamo PA92 Operator's Manual page 82

Made for use with smaller tractors in the 35 HP range, the rear mounted PA92 is your first choice when you
have the need to get in those hard to reach areas such as ditches and culverts to take care of light duty
vegetation. Stretch around waterways or ponds or mow along the roadside with ease. Grounds and roadway
maintenance is simplified when you have this boom on your team.
The PA92 mounts to the rear of the tractor utilizing a 3-point hitch. This allows for ease of disconnect and
convenient storage on a jackstand when not in use.
The controls are located at the operator's fingertips. These cable controls are connected to the hydraulic
system located away from the driver in case of hose failure.
The boom arms are two-piece and use parallel linkage. These strong arms are made of A50 grade square
steel tubing. All of the hydraulic systems; pumps, hoses and connections are strategically placed to prevent
damage from obstacles such as fencing tree-limbs, etc. Boom reach is approximately 14' when fully extended.
A hydraulic lift cylinder is strategically placed for maximum clearance when boom is fully extended.
A self-contained hydraulic system bypasses utilizing tractor hydraulics which allows for use on smaller tractors
with a minimum of 35 HP.
The 48" flail head is also available for areas that need a precise cut such as parks, playgrounds, and school
grounds.
Rotary cutting head is made for cutting light vegetation up to 2" in diameter, the rotary head has a cutting
swatch of 59 -3/4". Featuring two 1/2" x 4" x 19" tempered steel blades, this head is an asset not only around
ponds and waterways, but also in roadside applications.
Indicates an imminently hazardous situation that, if not avoided, WILL result in DEATH OR
VERY SERIOUS INJURY.
Indicates an imminently hazardous situation that, if not avoided, COULD result in DEATH
OR SERIOUS INJURY.
Indicates an imminently hazardous situation that, if not avoided, MAY result in MINOR
INJURY.
Identifies special instructions or procedures that, if not strictly observed, could result in
damage to, or destruction of the machine, attachments or the environment.
PA92 04/09
© 2009 Alamo Group Inc.
INTRODUCTION
Introduction Section 2-2