Alamo PA92 Operator's Manual page 22

Relieve hydraulic pressure prior to doing any maintenance or repair work
on the Implement.
blocked up, disengage the PTO, and turn off the tractor engine. Push
and pull the Remote Cylinder lever in and out several times prior to
starting any maintenance or repair work.
Always disconnect the main PTO Driveline from the Tractor before performing service on
the Implement. Never work on the Implement with the tractor PTO driveline connected and
running. Rotating Parts, Blades or Drivelines could turn without warning and cause immedi-
ate entanglement, injury or death.
Always maintain the safety signs in good readable condition. If the safety signs are missing,
damaged, or unreadable, obtain and install replacement safety signs immediately.
Do not modify or alter this Implement.
Implement, any of its components or any Implement function.
Never work under the Implement, the framework, or any lifted
component unless the Implement is securely supported or blocked up
to prevent sudden or inadvertent falling which could cause serious
injury or even death.
Never attempt to lubricate, adjust, or remove material from the Implement while it is in
motion or while tractor engine is running.
Periodically inspect all moving parts for wear and replace when
necessary with authorized service parts. Look for loose fasteners, worn
or broken parts, and leaky or loose fittings. Make sure all pins have
cotter pins and washers. Serious injury may occur from not maintaining
this machine in good working order.
Do Not fill fuel tank while engine is running. Refuel only after engine has cooled down. If
fuel is spilled, move machine away from the area of the spill and avoid creating any source
of ignition until the gasoline has evaporated.
PA92 04/09
© 2009 Alamo Group Inc.
SAFETY
Place the Implement on the ground or securely
(S3PT-09)
(S3PT-11)
Do not permit anyone to modify or alter this
(SG-14)
(SG-20)
(SG-21)
(SG-28)
Safety Section 1-14
(SG-5)
(SG-8)