Power Connections - Eagle SUPRAPRO I.D. Installation And Operation Instructions Manual

POWER CONNECTIONS

NOTE! INSTALL THE TRANSDUCER BEFORE MAKING THE POWER
CONNECTIONS!
The SupraPro I.D. works from a 12 volt DC system only. For the best
results, run the power cable directly to the boat's battery. Keep the power
cable away from other boat wiring, especially the engine's wires. This will
give the best isolation from electrical noise. If the supplied cable is not long
enough to reach the battery, splice #18 gauge insulated wire to it. You can
attach the power cable to an accessory or power buss, however, you may
have problems with electrical interference. Make certain to attach the in-
line fuse holder to the positive lead as close to the battery or terminal strip
as possible. This will protect both the unit and the power cable in the event
of a short. The SupraPro I.D. uses a 3-amp fuse.
Do not use this product without a 3-amp fuse wired into the power cable!
Failure to use a 3-amp fuse will void your warranty!
This unit has reverse polarity pro-
tection. No damage will occur if
the power wires are reversed.
However, the unit will not work
until the wires are attached cor-
rectly.
DASH MOUNT
WARNING!
TO TRANSDUCER
5
BLACK
WIRE
12 VOLT
RED
WIRE
3 amp
FUSE