Creda HB48283 Instructions For Installation And Use Manual page 28

CARE AND CLEANING
Take particular care not to damage the inner surface of the door inner
glass that is coated with a heat reflective layer. Do not use scouring
pads, or abrasive powder, which will scratch the glass. Ensure that the
glass panel is not subjected to any sharp mechanical blows.
Stubborn stains can be removed by using a fine steel wool pad. For slight soil-
ing the inner glass panel may be cleaned, while still warm, without removing it
from the door. After cleaning, rinse and dry with a soft cloth.
CLEANING THE DOORS
SIDE OPENING DOORS
Cleaning the door glass is the same as the drop down doors, except take
care to support the weight of the inner glass when removing and refitting.
DROP DOWN DOORS
Remove the door inner glass as follows.
1. Open the door fully and unscrew the two screws securing the glass panel so
that the securing brackets can be turned. There is no need to remove the
screws completely.
2. Turn the brackets so that the glass can be
removed and cleaned at the sink (Fig. 1.)
3. The inside of the outer door glass can now be cleaned while still fitted to
the cooker.
NEVER OPERATE THE COOKER WITHOUT THE INNER
DOOR GLASS IN POSITION.
Refit the door inner glass as follows.
1. NOTE: The inner door glass has a special reflective coating on one side.
Replace the door inner glass so that the statement: "IMPORTANT THIS
FACE TOWARDS THE OVEN" can be read from the inner side of the door.
2. Turn the two securing brackets back to their
original position to retain the glass and tighten
the screws. (Fig. 2.)
28
Fig. 1.
Fig. 2.
Glass
Glass