Creda HB48283 Instructions For Installation And Use Manual page 14

ELECTRONIC CLOCK & AUTOMATIC
OVEN TIMER OPERATION
Minute Cook End
Time Manual
Minder Period
A
U
T
O
Minute Cook End
Time Manual
Minder Period
Note 1 When cooking automatically the Cook Period can be checked at any time by
simply pressing the Cook Period button.
OTHER NOTES ON TIMER OPERATION
1. When cooking Automatically the Cook Period can be checked at any time simply by
pressing the Cook Period button.
2. When cooking Automatically the End Time can be checked at any time by simply pressing
the End Time button.
3. Having set a Cook Period and End Time an electronic device stores the information. The
device within the timer will switch the oven(s) on and off at the required times.
4. When setting an Auto Cooking Programme and a mistake is made, to clear:–
(a) Press and hold in the "Cook Period" button.
(b) With the Cook Period button still held in, return the display to
"–" button.
(c) Release the "Cook Period" & "–" buttons, and the display will revert to the time of day
and the "Auto" symbol will flash.
(d) Press & release the "Manual" button.
(e) Start the sequence again.
5. If at any time the display shows three flashing zero's 0.00. It is likely that the electricity
supply to the oven has been interrupted. Reset the timer to the correct time of day.
Food in the oven may, therefore, not have been cooked, before serving check food is
thoroughly heated and completely cooked.
6. To set each function always press and hold the required function button and at the
same time press "+" or "–" buttons.
Note: Between the hours of 22.00 & 06.00 the display dims to prevent glare.
However, if you should operate a button during this period, the timer will return to
normal brightness for a few seconds and then dim again.
14
TO CANCEL AN AUTO COOKING PROGRAMME BEFORE
THE COOK PERIOD HAS FINISHED.
Step 1 Turn the oven control(s) to the OFF position.
Step 2 Press and hold in the "Cook Period" button.
Step 3 With the "Cook Period" button still held in, return the display to
0.00 by pressing the "–" button.
Step 4 Release the "Cook Period" and "–" buttons and the display will
revert to the time of day and the "Auto" symbol will flash.
Step 5 Press the "Manual" button to return the oven(s) to "Manual"
operation. The "Auto" symbol will go out.
A
by pressing the
U
T
O