Enter And Directional Buttons; Shuffle Camera Views - GE Security DIGIA II User Manual

Enter and directional buttons

You can use the Enter and directional buttons for a variety of tasks.

Shuffle camera views

In a multiple-channel display mode, you can customize where each camera view is displayed. To shuffle the
camera views, do the following:
1. Press Display until you are in the multiple-channel view you want to be in. You must at least be in the
2 x 2 display. If your unit is capable of more channels, you can also be in the 3 x 3 or 4 x 4 display.
2. Press Enter once. Select should appear in your upper left video display (Figure 19).
Figure 19. Shuffle views
3. Use the directional buttons to move the Select to the video display you'd like to change.
4. Once you are in the channel you want to change, press the channel number of the video channel you
would like to display in this area.
For instance, if you want channel 2 to display in the area normally showing channel 1. Press Enter to
show the Select message. Then press 2. Channel 2 will now display where channel 1 was, and channel
1 will display where channel 2 was (Figure 20 on page 28).
CH01
Select
CH03
12-19-2006 TUE R01
CH02
CH03
01% FAN 10:39:32a
Chapter 3 27
Setup