Bassrt; Bass Xov (Bass Crossover); Category (Room); Chorus - Lexicon PCM NATIVE Owner's Manual

BassRT

This parameter controls bass reverb time. It is closely associated with the Bass
Crossover and Reverb Time parameters. BassRT is a multiple of Reverb Time
that applies to signal below the frequency described by Bass Crossover. If
BassRT is less than 1.0, then the low frequency part of the reverb tail will be
shorter than the midrange part. If BassRT is greater than 1.0, then the low fre-
quency part of the tail is longer.

Bass XOV (Bass Crossover)

The Bass XOV parameter is closely tied to the BassRT parameter. It represents
the frequency below which BassRT has an effect. Note that there are two of
these parameters in the Room algorithm. One is tied to BassRT, the other is
found in the Pattern settings menu and affects the BassBoost.

Category (Room)

This parameter lets you select a specific category from which a room response may
be chosen. Changes here have a direct effect on the Pattern Selector parameter.

Chorus

This parameter (in the Concert Hall algorithm) controls the rate at which the re-
verb chorus is run. Low values may cause a barely-noticeable undulation. Higher
values will cause noticeable wobble in fixed-pitch instruments such as piano. It is
closely tied to the Reverb Chorus Depth parameter.

Chorus Depth

This parameter (in the Concert Hall algorithm) controls the amount of randomization
of the chorus tap. Higher values are generally preferred in order to minimize reverb
coloration. Pitch effects may result and are closely tied to the Chorus parameter.
43