Connecting The Gas - Dacor Epicure OB36 Installation Instructions Manual

Connecting the Gas

Gas Connection - Natural Gas
• Units equipped for use with natural gas ship with a
regulator assembly with 3/4" pipe attached and an
additional 3/4" nipple.
• The regulator assembly is also equipped with a 3/4" to
1/2" reducer on the inlet side.
1. Connect the factory supplied regulator assembly to the
gas inlet at the back right bottom corner of the appli-
ance. Make sure the arrow on the regulator points in
the direction of the gas flow (towards the grill).
2. Connect a 1/2" nipple to the regulator.
3. Install an approved flexible gas line from the regulator
to the gas shut-off valve.
natural gas
connection
Regulator assembly
(included PN 700597NG)
1/2" Nipple (not included)
Flexible gas line (not included)
Gas Connection - Whole House LP Gas
1. Connect the LP regulator assembly (special order from
Dacor) to the gas inlet at the back right bottom corner
of the appliance. Make sure the arrow on the regulator
points in the direction of the gas flow (towards the grill).
2. Connect a 1/2" nipple to the regulator.
14
Installation Instructions
noTe
3. Install an approved flexible gas line from the regulator
to the gas shut-off valve.
whole house lp
gas connection
Regulator assembly
(special order PN 700597LP)
1/2" Nipple (not included)
Flexible gas line (not included)
Gas Connection - LP Gas Cylinder Hose
1. Connect the supplied 3/4" coupling and nipple to the
gas inlet at the back right bottom corner of the unit.
2. Connect the included LP cylinder hose to the nipple.
3/4" Coupling and
nipple (included)
Connect
to outdoor grill
LP regulator and hose
assembly (included)
PN 72310 for
OB36 and OBS36
lp cylinder hose connection
PN 101578 for
OB52 and OBS52