Chapter 3 Performing Network And System Management; Configuring Network Settings - NETGEAR STM150 - ProSecure Web And Email Threat Management Appliance Reference Manual

Performing Network and System
3.
Management
This chapter describes the network settings, the system management features, and ways to
improve the performance of the STM. If you have used the Setup Wizard, you have already
configured some of these settings, but there are situations in which you might want to modify
them. This chapter contains the following sections:
•

Configuring Network Settings

• Configuring Session Limits and Timeouts
• Configuring the Network Refresh and Permanent MAC Address Bindings
• Configuring the HTTP Proxy Settings
• About Users with Administrative and Guest Privileges
• Configuring Remote Management Access
• Using an SNMP Manager
• Managing the Configuration File
• Updating the Software
• Configuring Date and Time Service
• Managing Digital Certificates
• Managing the Quarantine Settings
• Managing the STM's Performance
Configuring Network Settings
If you have used the Setup Wizard, you might already have configured the Web
Management Interface and maximum transmission unit (MTU) settings; the Network Settings
screen allows you to modify these settings and to specify the interface speed and duplex
settings.
The STM requires a valid IP address to retrieve online updates and to enable access to its
Web Management Interface. If you have used the Setup Wizard to configure the STM, you
have already specified the management interface name and address settings and the size of
the MTU. In addition to modifying these settings, the Network Settings screen also allows
you to specify the interface speed and duplex settings for the management interface, for the
on this page
on page 56
on page 60
on page 64
on page 65
on page 67
on page 71
on page 74
on page 76
on page 81
on page 82
Chapter 3. Performing Network and System Management
on page 57
on page 61
3
| 52