HP J3278B - SureStore CD-ROM Server/Tower 7 NAS Server User Manual page 89

Parameter name
SetCommunityName
TrapDestination
TrapCommunityName
SystemContact
SystemName
SystemLocation
AuthenticationTrap
[NetWare]
NWEnable
Frame_802.2
Frame_802.3
Frame_EthernetII
Frame_SNAP
ServerName
InternalNetAddress
BurstMode
BinderyEnable
SupervisorPassword
BindAuthentication
NDSEnable*
NDSTreeName*
Default Value
= pass
= 0.0.0.0
= public
=
=
=
= disabled
= yes
= auto
= auto
= auto
= auto
= HPhhhhhh_NW
=xx-xx-xx-xx
= on
= Yes
= PASS
=
= Yes
=
Description
Specifies the community that has read-write access
to all supported SNMP objects except read only
objects. It corresponds to the writeCommunity
SNMP object.
Specifies the Internet Address which SNMP traps
are sent to. It corresponds to the trapAddress SNMP
object. Default is 0.0.0.0, i.e. all SNMP traps are
disabled.
Specifies the community for all generated SNMP
traps. It corresponds to the trapCommunity SNMP
object.
Optional entry which should be in plain text and may
be used to show the name of the system contact
person.
Optional entry which should be in plain text and may
be used to show the name of the location of the
system.
Optional entry which should be in plain text and may
be used to show the name of the location of the
system.
Enables or disables the SNMP authentication failure
traps. It corresponds to the
snmpenableAuthenTraps (MIB-II) SNMP object.
Enable or disable NetWare support.
Enable or disable the 802.2 frame type.
Enable or disable the 802.3 frame type
Enable/disable the Ethernet II frame type
Enable or disable the SNAP frame type.
NetWare server name to be presented to the
NetWare clients, where hhhhhh are the last 6 digits
of the LAN hardware address.
Internal network address.
Burst mode enable.
Enables/Disables bindery mode login. Set to disable
to increasing system security when using NDS. The
supervisor will always be able to login in bindery
mode even if this parameter is set to no.
Supervisors Password.
Server Name.
Enable/Disable NDS
Name of the Tree you wish to install the server into.
The Config.ini File B-3