Restoring Factory Default Settings - HP J3278B - SureStore CD-ROM Server/Tower 7 NAS Server User Manual

Restoring Factory Default Settings

The factory default settings can be restored if required (for
example, if you have accidently disabled all network protocols).
Restoring the settings can be done in three ways:
•
•
•
•
Step by step instructions for each method are given below.
Note
Using a Web
Follow these steps to reset to the defaults settings using a
browser:
browser
1. Start the Netscape Navigator or Internet Explorer and go to
2. On the Management page, click Factory default.
3. On the next page, confirm by clicking Set defaults. The factory
Using FTP
Follow the steps below to restore the default settings:
1. Log in to the CD-ROM server with the command:
2. You will be prompted for user id and password. Use the user
3. Issue the command
4. Log out using the command
Using a Web browser on a TCP/IP network.
Using FTP on a TCP/IP network.
Using the config.ini file in a text editor
Using the Push button.
The LAN hardware (MAC) address specified in the
HardwareAddress parameter will remain unchanged, but all
other parameters are reset. This includes the Internet (IP)
address if one had been configured.
the Management page as outlined under "Configuration
Using a Web Browser" in chapter 5.
default setting will now be restored and the CD-ROM server
will then automatically restart.
ftp <IP address or host name>
where
<IP address or host name>
name assigned to the CD-ROM server.
id , which has the default password
root
id with the highest priority).
settings. The unit will then automatically restart.
your FTP version.
is the IP address or host
to restore the default
get defaults
,
quit bye
( is the user
pass root
or depending on
exit
Troubleshooting A-9