HP J3278B - SureStore CD-ROM Server/Tower 7 NAS Server User Manual page 24

3-2 Network Configuration
Chapter 5 describes different methods that you can use to set
the NetWare configuration in the HP CD-ROM Server; the
required configuration settings are described below.
Parameter name
TimeZone
TimeSyncSource
NDSEnable
NDSTreeName
NDSServerContext
NDSAdminName
NDSAdminPassword
NDSInstall
The NDS server installation will begin 5 seconds after saving
the configuration settings to the CD-ROM server. The
installation should take about 20 seconds, after which users will
be able to access the CD-ROM server using NDS mode.
Refer to chapter 4 for instructions on accessing your CD-ROM
server.
After installation you will have to logout and then login again to
have all the necessary Rights on the HP CD-ROM Server object
and the associated volume. Using NetWare Administrator, you
will find a new server object and corresponding volume object in
the context you chose above.
If there are any problems with the installation you can check for
errors in the logfile.txt file in the CD-ROM Server's config
directory. Refer to "NetWare NDS Installation Errors" in
appendix A if you need more information.
Value Description
Must be set to the correct Time Zone
=
that the CD-ROM server is operating in.
Default is None. Set to NDS to enable
= None the HP CD-ROM Server to get its time
from the NetWare network.
Must be set to yes to enable the NDS
= yes
login.
The name of the tree that you want to
=
install the server into.
The context in the NDS tree where you
=
want to install the server.
The distinguished name of a user or
administrator with Supervisor or Create
=
rights in the context where you want to
install the server.
The password of the administrator
entered in NDSAdminName shown
=
above. Once written, this password will
appear as ******.
Change this to yes when you are ready
= no
to install the server.