Compaq 230050-001 - StorageWorks NAS B3000 Model N900 Server Quick Start Manual page 46

Configuration Setup
3. Go to the NAS device and power it on. It will be several minutes before the
4. Open Internet Explorer on the Windows-based PC. Enter
Note:
5. Using the information from
6. Click the Finish icon to complete Rapid Startup. If a reboot is required, Rapid
7. The browser will refresh to the status page of the NAS device. The refresh
8. For cluster deployments only, repeat steps 3 - 7 with the second node. After
46
NAS device is accessible on the network.
number of the NAS b3000 v2 followed by a hyphen (
Press Enter. This launches the WebUI configuration application (Rapid
Startup) on the target HP StorageWorks NAS device as shown in
Example:
http://D4059ABC3433-:3201
The NAS device will respond when the NAS operating system has started.
your information is correct when the configuration review screen is displayed,
as shown in Figure 10. Online help is available for all pages by clicking the
"?" in the right side of the Web UI.
Startup will present a message that a reboot is occuring.
may take several minutes if the device was restarted. Click on the HP utilities
tab and select the SAN Connection Tool. Do not connect storage until
instructed to do so by the tool.
the second node is configured, follow the online Cluster Install Guide found in
the Cluster tab of the Web UI. Additional information can also be found in
Chapter 4 of this document as well as the cluster section of the administration
guide.
Table 3, fill in the screens that follow. Verify that
, the serial
http://
), followed by
-
Figure
NAS b3000 v2 Quick Start Guide
.
:3201
9.