Table of Contents
Advertisement
Quick Links
VWIC-2MFT-T1-DIR, VWIC-2MFT-E1-DIR
Installation Instructions
This document contains the following sections:
•
•
•
•
•
•
•
•
•
•
•
Overview
The Cisco VWIC-2MFT-T1-DIR and VWIC-2MFT-E1-DIR Voice/WAN Interface Cards support data
applications on the Cisco MWR 1941-DC Mobile Wireless Edge Router for T1/E1 networks. These
cards are dual-port, T1/Fractional T1 or E1/Fractional E1, Drop and Insert Multiplexers with integrated
T1 CSU/DSUs or E1 DSUs. The T1 version supports framed and unframed traffic, and the E1 version
supports framed traffic and unframed traffic that conforms to the ITU-T G.703 standard for full 2.048
Mbps bandwidth.
The Drop and Insert multiplexer diverts (drops) streams of an aggregate Time Division Multiplexed
(TDM) traffic stream, and introduces (inserts) different streams for transmission in the time slots that
were previously occupied by the dropped streams. Each VWIC supports a limited channelized capability
where the T1 or E1 can be flexibly split into two fractional channel groups, one on each port or two on
one port. The switching operation can be maintained through router restarts and reloads of Cisco IOS
software.
Corporate Headquarters:
Cisco Systems, Inc., 170 West Tasman Drive, San Jose, CA 95134-1706 USA
Copyright © 2003 Cisco Systems, Inc. All rights reserved.
Overview
Safety Guidelines
Installing the VWIC-2MFT-T1-DIR, VWIC-2MFT-E1-DIR
Connecting the T1/E1 Multiflex VWIC Card
Configuring the VWIC-2MFT-T1-DIR, VWIC-2MFT-E1-DIR
Y-Cable Specifications
RJ-48C Pinout Configuration
Understanding the LEDs
Translated Safety Warnings
Obtaining Documentation
Obtaining Technical Assistance
Advertisement
Table of Contents
Related Manuals for Cisco VWIC-2MFT-T1 - Multiflex Trunk Voice/WAN Interface Card Expansion Module
Summary of Contents for Cisco VWIC-2MFT-T1 - Multiflex Trunk Voice/WAN Interface Card Expansion Module
-
Page 1: Installation Instructions
Each VWIC supports a limited channelized capability where the T1 or E1 can be flexibly split into two fractional channel groups, one on each port or two on one port. The switching operation can be maintained through router restarts and reloads of Cisco IOS software. - Page 2 Each card also features protection switch solid state relays on the line interfaces, which together with redundancy logic and relay control added in a Cisco IOS feature set on the MWR 1941-DC router, can be used to provide T1/E1 Protection Switching between redundant routers in applicable implementations.
-
Page 3: Safety Guidelines
Safety Guidelines This section provides safety guidelines that you should follow when working with any equipment that connects to electrical power or telephone wiring. Safety Warnings Safety warnings appear throughout this publication in procedures that, if performed incorrectly, might harm you. A warning symbol precedes each warning statement. Warning IMPORTANT SAFETY INSTRUCTIONS This warning symbol means danger. - Page 4 Warnung WICHTIGE SICHERHEITSHINWEISE Dieses Warnsymbol bedeutet Gefahr. Sie befinden sich in einer Situation, die zu Verletzungen führen kann. Machen Sie sich vor der Arbeit mit Geräten mit den Gefahren elektrischer Schaltungen und den üblichen Verfahren zur Vorbeugung vor Unfällen vertraut. Suchen Sie mit der am Ende jeder Warnung angegebenen Anweisungsnummer nach der jeweiligen Übersetzung in den übersetzten Sicherheitshinweisen, die zusammen mit diesem Gerät ausgeliefert wurden.
- Page 5 Varning! VIKTIGA SÄKERHETSANVISNINGAR Denna varningssignal signalerar fara. Du befinner dig i en situation som kan leda till personskada. Innan du utför arbete på någon utrustning måste du vara medveten om farorna med elkretsar och känna till vanliga förfaranden för att förebygga olyckor. Använd det nummer som finns i slutet av varje varning för att hitta dess översättning i de översatta säkerhetsvarningar som medföljer denna anordning.
- Page 6 VWIC-2MFT-T1-DIR, VWIC-2MFT-E1-DIR Installation Instructions 78-15842-01...
-
Page 7: Electrical Equipment Guidelines
Electrical Equipment Guidelines Follow these basic guidelines when working with any electrical equipment: Before beginning any procedures requiring access to the chassis interior, locate the emergency • power-off switch for the room in which you are working. • Disconnect all power and external cables before moving a chassis. •... -
Page 8: Fcc Class A Compliance
You can determine whether your equipment is causing interference by turning it off. If the interference stops, it was probably caused by the Cisco equipment or one of its peripheral devices. If the equipment causes interference to radio or television reception, try to correct the interference by using one or more of the following measures: Turn the television or radio antenna until the interference stops. - Page 9 How you connect the ports of the T1/E1 Multiflex VWIC depends on whether you are using the Cisco MWR 1941-DC router in a redundant or a non-redundant configuration. Whether you are using the Cisco MWR 1941-DC router in a redundant or non-redundant configuration depends on the implementation of the router. For information on MWR 1941-DC router implementations, see the Cisco MWR 1941-DC Mobile Wireless Edge Router Software Configuration Guide.
- Page 10 If you choose to use the T1/E1 Multiflex VWIC in a non-redundant configuration, you must close the Note relays on the card using the standalone subcommand. For more information, see the “Cisco MWR 1941-DC Mobile Wireless Edge Router Software Configuration Guide.”...
- Page 11 Stubs MWR 1941-DC Junction point Patch panel MWR 1941-DC Y-Cable • All signals that propagate in the same direction must share the same twisted pair. For example, RX TIP and RX RING must form a single twisted pair. • All unused twisted pairs should be cut flush on both ends of the cable. Any unused wire in a twisted pair where one wire is in use should be cut flush at both ends.
-
Page 12: Understanding The Leds
Understanding the LEDs The T1/E1 Multiflex VWIC has six LEDs (three for each port) as listed in Table Table 2 T1/E1 Multiflex Trunk Interface Card LEDs Description Color LP LED On means that a loopback or line state is Amber detected or is manually set by the user. - Page 13 Aviso Antes de executar um dos seguintes procedimentos, certifique-se que desligou a fonte de alimentação de energia do circuito de corrente contínua. ¡Advertencia! Antes de proceder con los siguientes pasos, comprobar que la alimentación del circuito de corriente continua (CC) esté cortada (OFF). Varning! Innan du utför någon av följande procedurer måste du kontrollera att strömförsörjningen till likströmskretsen är bruten.
-
Page 14: Obtaining Documentation
överspänningsskyddets omkopplare i TILL-läget. Obtaining Documentation World Wide Web You can access the most current Cisco documentation on the World Wide Web at http://www.cisco.com, http://www-china.cisco.com, or http://www-europe.cisco.com. Documentation CD-ROM Cisco documentation and additional literature are available in a CD-ROM package, which ships with your product. -
Page 15: Ordering Documentation
Cisco. Cisco Connection Online Cisco continues to revolutionize how business is done on the Internet. Cisco Connection Online is the foundation of a suite of interactive, networked services that provides immediate, open access to Cisco information and resources at anytime, from anywhere in the world. -
Page 16: Technical Assistance Center
Technical Assistance Center The Cisco Technical Assistance Center (TAC) is available to warranty or maintenance contract customers who need technical assistance with a Cisco product that is under warranty or covered by a maintenance contract. To display the TAC web site that includes links to technical support information and software upgrades and for requesting TAC support, use www.cisco.com/techsupport. - Page 17 VWIC-2MFT-T1-DIR, VWIC-2MFT-E1-DIR Installation Instructions 78-15842-01...
- Page 18 CCIP, CCSP, the Cisco Arrow logo, the Cisco Powered Network mark, Cisco Unity, Follow Me Browsing, FormShare, and StackWise are trademarks of Cisco Systems, Inc.; Changing the Way We Work, Live, Play, and Learn, and iQuick Study are service marks of Cisco Systems, Inc.; and Aironet,...
Need help?
Do you have a question about the VWIC-2MFT-T1 - Multiflex Trunk Voice/WAN Interface Card Expansion Module and is the answer not in the manual?
Questions and answers