Table of Contents
Advertisement
MWR 1941-DC
MWR 1941-DC
•
•
RJ-48C Pinout Configuration
The T1/E1 Multiflex VWIC uses an RJ-48C connection, as shown in
Figure 3
8 7 6 5 4 3 2 1
RJ-48C connector
Table 1
Table 1
Pin
1
2
3
4
5
6
7
8
78-15842-01
Stubs
E1/
T1
E1/
T1
All signals that propagate in the same direction must share the same twisted pair. For example, RX
TIP and RX RING must form a single twisted pair.
All unused twisted pairs should be cut flush on both ends of the cable. Any unused wire in a twisted
pair where one wire is in use should be cut flush at both ends.
RJ-48C Connection
shows the pinout configuration of the RJ-48C connectors on the T1/E1 Multiflex VWIC.
RJ-48C Pinout
Junction point
Patch panel
Y-Cable
Description
receive tip
receive ring
receive shield
transmit tip
transmit ring
transmit shield
not used
not used
VWIC-2MFT-T1-DIR, VWIC-2MFT-E1-DIR Installation Instructions
Figure
3.
11
Advertisement
Table of Contents
Need help?
Do you have a question about the VWIC-2MFT-T1 - Multiflex Trunk Voice/WAN Interface Card Expansion Module and is the answer not in the manual?
Questions and answers