Cisco N5K-M1600 - Expansion Module - 6 Ports Troubleshooting Manual page 93

Troubleshooting guide
Table of Contents

Advertisement

Chapter 5
Troubleshooting SAN Switching Issues
S e n d d o c u m e n t c o m m e n t s t o n e x u s 5 k - d o c f e e d b a c k @ c i s c o . c o m .
switch# show fspf vsan 200 interface port-channel 200
FSPF interface port-channel 200 in VSAN 200
FSPF routing administrative state is active
Interface cost is 125
Timer intervals configured, Hello 20 s, Dead 80 s, Retransmit 5 s
FSPF State is INIT
Statistics counters :
Number of packets received : LSU
Number of packets transmitted : LSU
Number of times inactivity timer expired for the interface = 4
In the example:
Note
The dead timer is not set to the default (80 seconds) on the first switch. Check the neighboring
switch (MDS) configuration to make sure it matches.
FSPF is not in FULL state. This indicates a problem.
In the interface configuration mode, change the fspf dead-interval value so that the same values match
Step 4
on both switches.
switch(config)# interface san-port-channel 200
switch(config-if)# fspf dead-interval 80 vsan 200
Verify that the FSPF is in FULL state after the change. Ensure that there is a route for VSAN traffic with
Step 5
the show fspf internal route vsan <vsan-id> command.
Example:
switch# show fspf internal route vsan 200
FSPF Unicast Routes
---------------------------
VSAN Number
-----------------------------------------------
switch# show fspf vsan 200 interface san-port-channel 200
FSPF interface san-port-channel 200 in VSAN 200
FSPF routing administrative state is active
Interface cost is 125
Timer intervals configured, Hello 20 s, Dead 80 s, Retransmit 5 s
FSPF State is FULL
Neighbor Domain Id is 0x18(24)
Neighbor Interface is san-port-channel 200 (0x000400c7)
Statistics counters :
Number of packets received : LSU
Number of packets transmitted : LSU
Number of times inactivity timer expired for the interface = 0
Possible Cause
There is a region mismatch on the switch.
The following example shows possible log messages from the show logging command log:
Example:
OL-25300-01
Dest Domain
Route Cost
200
0x18(24)
4
LSA
4
Hello 41
4
LSA
4
Hello 29
Next hops
125 san-port-channel 200
8
LSA
8
Hello 47
8
LSA
8
Hello 70
Cisco Nexus 5000 Series Troubleshooting Guide
FC Services
Error packets 35
Retransmitted LSU
0
Error packets 4
Retransmitted LSU
0
5-21

Hide quick links:

Advertisement

Table of Contents
loading

Table of Contents