Fabric Manager Tools And Cli Commands - Cisco N5K-M1600 - Expansion Module - 6 Ports Troubleshooting Manual

Fabric Manager Tools and CLI Commands

S e n d d o c u m e n t c o m m e n t s t o n e x u s 5 k - d o c f e e d b a c k @ c i s c o . c o m .
Fabric Manager Tools and CLI Commands
This section highlights the tools and CLI commands that are commonly used to troubleshoot problems.
These tools and commands are a portion of what you may use to troubleshoot your specific problem.
The following chapters in this guide may describe additional tools and commands specific to the
symptoms and possible problems covered in that chapter.
NX-OS Tips
Displaying what is required from the configuration
switch# show running-config interface
version 4.0(1a)N2(1)
interface vfc29
no shutdown
bind interface Ethernet1/29
interface fc2/3
no shutdown
switchport speed 1000
switchport mode SD
interface fc2/4
interface Ethernet1/1
speed 1000
Displaying within Config Mode
With NX-OS, you can display required data from within the configuration mode, so there is no need to
back out to the switch prompt.
switch(config)# show run
switch(config)# show interface brief
Pipe command
switch# show logging |
egrep
grep
head
last
less
no-more
sed
wc
begin
count
exclude
include
Cisco Nexus 5000 Series Troubleshooting Guide
1-4
Egrep
Grep
Stream Editor
Display last lines
Stream Editor
Turn-off pagination for command output
Stream Editor
Count words, lines, characters
Begin with the line that matches
Count number of lines
Exclude lines that match
Include lines that match
Chapter 1 Troubleshooting Overview
OL-25300-01