Switch-Profile Deletion Failure - Cisco N5K-M1600 - Expansion Module - 6 Ports Troubleshooting Manual

Switch-profile Deletion Failure

S e n d d o c u m e n t c o m m e n t s t o n e x u s 5 k - d o c f e e d b a c k @ c i s c o . c o m .
Use the show system internal csm info trace command to view events, trace, and error messages.
Note
First time merge failure
Possible Cause
When peer switches are trying to synchronize configurations, the merge might fail when validating
received configurations.
Solution
Use the show switch-profile status command to view which commands failed validation.
This implies that the commands on both the switches are configured differently.
Perform the following to correct the configurations:
•
•
•
•
Merge after peers that were in sync previously
Possible Cause
If peers were in sync and connectivity was lost, and conflicting configuration changes were made on the
switches, then the merge would fail.
Solution
Use the show switch-profile status command to view which commands failed the merge.
Correct the configurations and reissue the commit from the peer with the corrected configuration.
Merge after reload
Possible Cause
After a switch is reloaded, it sends its switch-profile configuration to the peer. If there was a
configuration change done under SP for the peer that was not reloaded, then the merge fails.
Solution
Use the show switch-profile status command to view which commands failed the merge.
Correct the configurations and reissue the commit.
Switch-profile Deletion Failure
A rollback is used to delete the configurations during a switch-profile deletion.
Cisco Nexus 5000 Series Troubleshooting Guide
9-6
Remove the sync-peers destination command from the switch-profile.
Use the show running switch-profile command on both peers to ensure that the configuration is
exactly the same under switch-profile.
Add back the sync-peers destination command to the switch-profile.
Reissue the commit.
Chapter 9 Troubleshooting Config-Sync Issues
OL-25300-01