Cisco N5K-M1600 - Expansion Module - 6 Ports Troubleshooting Manual page 111

Chapter 5 Troubleshooting SAN Switching Issues
S e n d d o c u m e n t c o m m e n t s t o n e x u s 5 k - d o c f e e d b a c k @ c i s c o . c o m .
•
•
•
Distribution failure
To resolve a configuration distribution failure to all switches for a CFS Region, perform the following
steps:
Verify that application distribution is enabled. For more information, see
Step 1
page
Verify that the application is in the same region on all switches.
Step 2
Using the CLI from each switch, enter the show cfs <application> name <application-name>
command.
Example (for device-alias application):
switch(config)# show cfs lock name ntp
Scope
--------------------------------------------------------------------------------
Switch WWN
--------------------------------------------------------------------------------
20:00:00:0d:ec:50:09:00 172.25.183.42
Total number of entries = 1
Example (application is capable of being merged; application is in Region Default):
switch(config)# show cfs application name device-alias
Enabled
Timeout
Merge Capable
Scope
Region
Example (application is capable of being merged; application is in Region 1):
switch# show cfs application name device-alias
Enabled : Yes
Timeout : 20s
Merge Capable : Yes
Scope : Physical-fc
Region : 1
OL-25300-01
Assigning a region to an application takes precedence in distribution over its initial physical scope.
CFS Regions configuration is not supported for deregistered applications (conditional services) or
a physical scope application that is currently locked.
Regions 1 through 200 are available for user configuration. Regions 201 through 255 are reserved
regions and are not available for user configuration.
31.
: Physical-fc-ip
IP Address
: Yes
: 20s
: Yes
: Physical-fc
: Default
"Overview" section on
User Name User Type
admin CLI/SNMP v3
Cisco Nexus 5000 Series Troubleshooting Guide
Cisco Fabric Services
5-39