Lexicon 960L V2.4 - INSTALLATION AND RELEASE NOTES REV 3 Installation Instructions Manual page 4

Installation Instructions & Release Notes
2. Press 1 to begin installation. A number of progress messages will appear. When this phase
of installation is complete (after about one minute), the following message will appear:
Install complete. Please remove CD from drive.
3. Remove the CD from the drive. Using the front panel standby button, power down the
system, wait a few seconds, then power up the system again. The 960L will take a little longer
to boot than normal.
If the LARC2 requires an update, the LARC2 will display the following menu:
Update needed on Larc2: Press '1' to update
4. Press 1 to begin the LARC2 update. This is the longest phase of the process, lasting about 10
minutes. The LARC2 will display a progress indicator. After the LARC2 update is complete,
the following message will appear:
Please enter serial number of the 960L from the back panel of
the 960L chassis. Do not use the serial number of the LARC2!
Enter numbers only. Do not enter first letter (shown as
Use minus for
with ENTER.
x_
Note:
When reinstalling Version 2.4, the unit will not ask to have the serial number re-
entered if this process was completed during a previous installation.
5. Enter the serial number as it appears on the back panel of the 960L mainframe. Do not enter
the first letter. Enter the numbers and the dash only. Press ENTER when finished. The
following message will appear:
Please re-enter serial number for verification . . .
x_
4
Press '0' to ignore
- : Use left arrow < for backspace : Finish
Lexicon
x )