Yaesu VX-60R Operating Manual page 57

12. If you store other numbers, repeat steps 4- 10 above, using a different DTMF memory
register.
13. When all required DTMF memories are filled to your satisfaction, press the PTT
switch to save the settings and exit to normal operation
You may check your work by monitoring the entered DTMF string. To do
this, repeat steps 1- 4 above, then press the MONI switch.
To send the telephone number:
1. Press the [ F/W ] key, then press the [ 9 ( DTMF )] key to activate
the DTMF Autodialer. The "MEM" indication display will ap-
pear in the display for a moment.
2. While the DTMF Autodialer is activated, first press the PTT switch, then press the
numerical key ([ 1 ] through [ 9 ]) corresponding to the DTMF memory string you wish
to send. Once the string begins, you may release the PTT switch, as the transmitter will
be held "on the air" until the DTMF string is completed.
3. To disable the DTMF Autodialer, press [ F/W ]
indication will appear in the display for a moment.
You can change the DTMF Audodialer sending speed, using Set Mode Item 16: DT SPD.
See page 71 for details.
You can also set a longer delay between the time you press the numerical key (correspond-
ing to the DTMF memory string; with PTT switch pressed) and the instant when the first
DTMF digit is sent, using Set Mode Item 15: DT DLY. See page 71 for details.
FT-60R O M
DTMF O
[ 9 ( DTMF )] again. The "CODE"
55