Table of Contents
Advertisement
O
2 ) Direct Keypad Frequency Entry
The desired operating frequency may be entered directly from the keypad.
To enter a frequency from the keypad, just press the numbered digits on the keypad in the
proper sequence.
Examples:
To enter 146.560 MHz, press [ 1 ]
To enter 146.5625 MHz (in 12.5 kHz), [ 1 ]
3 ) Scanning
Press and hold in either the [ ( MHz )] or [ ( MHz )] key
for one second to initiate upward or downward scanning,
respectively (Manual VFO Scan).
For scanning within a limited sub-band range, from the VFO
mode, press and hold in the [ V/M ( PRI )] key for one second
to begin scanning toward a higher frequency within the pre-
viously-defined sub-band (Programmed VFO Scan). Details
regarding sub-band setup may be found on page 36.
If you wish to reverse the direction of the scan (i.e. toward a
lower frequency, instead of a higher frequency), just rotate
the DIAL one click in the counter-clockwise direction while
the FT-60R is scanning. The scanning direction will be re-
versed. To revert to scanning toward a higher frequency once
more, rotate the DIAL one click clockwise.
The scanner will stop when it receives a signal strong enough to break through the Squelch
threshold. The FT-60R will then hold on that frequency according to the setting of the
"RESUME" mode (Set Mode Item 35: RESUME). Press the PTT switch momentarily to
cancel the scanning. This only stops the scan; it does not cause transmission to occur. See
page 35 for details regarding Scan Operation.
14
F
N
[ 4 ]
[ 6 ]
[ 5 ]
[ 6 ]
[ 4 ]
[ 6 ]
[ 5 ]
( Manual VFO Scan )
( Programmed VFO Scan )
FT-60R O
[ 0 ]
[ 6 ]
[ 2 ]
M
Advertisement
Table of Contents
