Yaesu VX-60R Operating Manual page 20

A
A special RF Squelch feature is provided on this radio. This feature allows you to set the
squelch so that only signals exceeding a certain S-meter level will open the squelch.
To set up the RF squelch circuit for operation, use the following procedure:
1. Press the [ F/W ] key, then press the [ 0 (
2. Rotate the DIAL knob to select Set Mode Item 37: RF SQL.
3. Press the [ F/W ] key momentarily to enable adjustment of this
Item.
4. Rotate the DIAL knob to select the desired signal strength level
for the squelch threshold (S-1, S-2, S-3, S-4, S-5, S-6, S-8, S-
FULL, or OFF).
5. Press the PTT switch to save the new setting and return to normal operation.
6. Finally, rotate the SQL knob fully clockwise.
The FT-60R's microprocessor includes programming which will measure the current bat-
tery voltage.
1. Press the [ F/W ] key, then press the [ 0 (
2. Rotate the DIAL knob to select Set Mode Item 12: DC VLT.
3. Press the [ F/W ] key momentarily to display the current DC volt-
age being supplied.
4. Press and hold the [ F/W ] key for one second to return to normal
operation.
18
O
RF S
C
) SET ] key to enter the Set mode.
B V
) SET ] key to enter the Set mode.
FT-60R O M