Yaesu VX-60R Operating Manual page 49

E
frequency which is stored in Memory Channel "000" for more than five seconds, the radio
will automatically transmit a brief (0.5 second) beep tone every 2.5 seconds until the EAI
timer expiration at the power level stored in that memory channel; it is NOT necessary for
the incapacitated person to press the PTT switch.
In the Continuous mode, when the FT-60R receives the CTCSS tone pair which is stored
in the Receiving Pager Code Memory (configured via Set Mode Item 31: PAG.CDR) on
the frequency which is stored in Memory Channel "000" for more than five seconds, the
radio will automatically transmit (with maximum microphone gain) continuously, until the
EAI timer expiration, at the power level stored in that memory channel; it is NOT neces-
sary for the incapacitated person to press the PTT switch.
Furthermore, if your call sign is stored in the radio via Set Mode Item 11: CW WRT and you have
enabled the CW identifier by Set Mode Item 10: CWID, the radio will transmit your callsign on
the air when the EAI feature is first engaged by the remote page, and every 10 minutes thereater.
The "callsign" ID can be changed to any desired sequence of characters, such as a name.
After sending the callsign or name, the radio will repeatedly transmit three tones for a user-
defined period of time (between 1 and 30 minutes). The callsign or name will be transmit-
ted every 10 minutes.
The Emergency Automatic ID (EAI) Feature requires that you (1) store the CTCSS Tone
Pair into the Receiving Pager Memory (see page 44 for procedure), and (2) store the desired
UHF coordination frequency into Memory Channel "000" (see page 28 for procedure).
To enable this feature:
1. Press the [ F/W ] key, then press the [ 0 (
2. Rotate the DIAL knob to select Set Mode Item 18: EAI.
3. Press the [ F/W ] key momentarily to enable adjustment of this
Set Mode Item.
4. Rotate the DIAL knob to select the desired EAI mode (Interval
EAI or Continuous EAI) and its transmit time (1-10, 15, 20, 30,
40, and 50 minutes) or OFF.
5. Press the PTT switch to save the new setting and exit to normal operation.
6. To disable the Emergency Automatic ID feature, just repeat the above procedure, ro-
tating the DIAL knob to select "OFF" in step 4 above.
When the Emergency Automatic ID feature is activated, the " "
icon will blink in the LCD.
The FT-60R will ignore the EAI feature when the (1) the squelch is open, (2)
there is an incoming the signal on the operating frequency, (3) the operating
frequency is the same as the frequency which is stored in the Memory Chan-
nel "000," or (4) a VHF frequency is stored in Memory Channel "000."
FT-60R O
A
M
E
ID EAI F
) SET ] key to enter the Set mode.
F
47