About The Transverter Output Terminal; Setup - Yaesu FTDX5000 Operating Manual

A
BOUT THE
You may connect an after-market transverter to the rear panel TRV jack. The output frequency is selectable from 14, 28,
and 50 MHz, and the output level is approximately –10 dBm (0.1 mW) at 50 Ohms.
1. Press the [ MENU ] button briefly to enter the Menu
mode.
2. Rotate the ( VFO-A )[ SELECT ] knob to select Menu
item "150 TUNE MY BAND".
3. Rotate the ( VFO-B )[ SELECT ] knob to select the de-
sired input frequency band of the transverter in menu
item (T14M OFF T28M OFF, or T50M OFF
T14M OFF T14M OFF T14M OFF T14M OFF, T28M OFF T28M OFF T28M OFF T28M OFF
4. Press the [ ENT ] button (one of the [ BAND ] buttons)
to change the parameter to "ON" (the "OFF
will change to "ON
ON ON ON ON").
5. Rotate the ( VFO-A )[ SELECT ] knob to select Menu
item "172 TGEN ETX-GND".
6. Rotate the ( VFO-B )[ SELECT ] knob to set this Menu
item to "ENABLE ENABLE" to enable the internal relay con-
ENABLE ENABLE
ENABLE
nected to the rear panel TX GND jack.
7. Press and hold the [ MENU ] button for at least two sec-
onds to save the new setting, and exit to normal opera-
tion.
Page 114
T
RANSVERTER
S
T50M OFF ).
T50M OFF T50M OFF T50M OFF
OFF" notation
OFF OFF OFF
( VFO-A )[ SELECT ] Knob
[ ENT ] Button
[ MENU ] Button ( VFO-B )[ SELECT ] Knob
O T
UTPUT
ETUP
Setting the Transverter Frequency Offset
You may set up the frequency display so that it shows the
frequencies of the transverter operating band (instead of
the 28 MHz band frequencies used as the "IF" on your
FT 5000).
DX
Example: Setting up the FT
144 MHz Transverter
1. Connect the 144 MHz transverter to the FT
2. Press the [ MENU ] button briefly, to enter the Menu
mode.
3. Rotate the ( VFO-A )[ SELECT ] knob to select the
Menu item which designates the input frequency band
from the transverter (040 GENE TRV 14M, 041
GENE TRV 28M, or 042 GENE TRV 50M).
4. Rotate the ( VFO-B )[ SELECT ] knob to select
"44MHz 44MHz" on the display.
44MHz 44MHz 44MHz
5. Press and hold the [ MENU ] button in for at least two
seconds to save the new setting and exit.
The "100 MHz" digit of the frequency is not displayed,
so when you are operating on 2 meters and see "45
MHz" on the frequency readout, this indicates "145
MHz" instead.
A :
DVICE
With the setup described above, tuning the actual operat-
ing range of the FT
DX
operating frequency of 144-145 MHz, with "44-45" being
displayed on the front panel of the transceiver.
FT
DX
ERMINAL
5000 display for use with a
DX
DX
5000 will correspond to transverter
5000 O M
PERATING
5000.
ANUAL