The IPO feature allows the operator to optimize the characteristics of the receiver front end, depending on the current noise
level and the strength of incoming signals.
VFO-A IPO Setup
Press the [ A ] button to activate VFO-A receiver (The
[ A ] button will glow red).
Move the [ IPO ] knob up or down to set the desired
characteristic of the VFO-A receiver front end, per the
chart below.
AMP1: Amplifies the incoming signal, using a low
AMP1
AMP1
AMP1
AMP1
distortion RF preamplifier (normally, the IPO
is set to this position).
AMP2: Increases receiver sensitivity.
AMP2
AMP2
AMP2
AMP2
Improves the IPO.
IPO1
IPO1
IPO1
IPO1:
IPO1
Bypasses the RF preamplifier, yielding di-
IPO2
IPO2
IPO2:
IPO2
IPO2
rect feed to the first mixer. As a result, the
IPO is improved more.
The selected receiver RF preamplifier will be indicated
in the IPO column of the Block Diagram Display.
Press the [ IPO ] knob briefly, to quickly set the IPO to
"AMP1".
[ IPO ] Knob
[ A ] Button
AMP1
AMP
AMP2
IPO1
IPO1
IPO2
A
:
DVICE
On the 10 MHz and lower bands, it generally is not necessary to use any preamplifier at all; selecting the "IPO
described above will increase the strong-signal-handling capability of the receiver, and usually result in more pleasant
reception due to reduced noise. If you can hear band noise with the preamplifiers disengaged, then a preamplifier is gener-
ally not needed.
FT
5000 O
DX
PERATING
C
IPO ( I
NTERCEPT
AMP
IPO2
M
ANUAL
ONVENIENCE
P
O
OINT
PTIMIZATION
VFO-B IPO Setup
Press the [ B ] button to activate VFO-B receiver (The
[ B ] button will glow orange).
Move the [ IPO ] knob up or down to set the desired
characteristic of the VFO-B receiver front end, per the
chart below.
AMP1: Amplifies the incoming signal, using a low
AMP1
AMP1
AMP1
AMP1
distortion RF preamplifier (normally, the IPO
is set to this position).
AMP2: Increases receiver sensitivity.
AMP2
AMP2
AMP2
AMP2
Improves the IPO.
IPO1
IPO1
IPO1
IPO1
IPO1:
The selected receiver RF preamplifier will be indicated
in the IPO column of the Block Diagram Display.
Press the [ IPO ] knob briefly, to quickly set the IPO to
"AMP1".
[ IPO ] Knob
AMP1
AMP2
F
EATURES
)
[ B ] Button
AMP
AMP
IPO1
IPO" position as
IPO
IPO
IPO
Page 51