Cw Id (Morse Identifier) Setup - Yaesu FT-7100M Operating Manual

ARTS
: AUTO RANGE TRANSPONDER SYSTEM
CW ID (Morse Identifier) Set up
The ARTS feature includes a CW identifier, as mentioned previously. The radio can be
instructed to send "DE (your callsign) K" in Morse code every nine minutes during ARTS
operation. The callsign may contain up to 6 characters.
Here's how to program the CW Ider:
1. Press and hold in the [ BAND ] key for 1/2 second to activate the "Menu" mode.
2. Rotate the Main Dial knob to select Menu # 6 (CWIDW ).
3. Press the [ BAND ] key momentarily to enable programming of your callsign.
4. You will notice the first character's entry slot blinking. While it is blinking, rotate the
Main Dial knob to select the desired character, then press the [ LOW ] key to move on to
the next character to the right.
5. Rotate the Main Dial knob to select the next number or letter, then press the [ LOW ] key
to move on the next character.
6. You may move to the back character by pressing the [ BAND ] key momentarily. Press and
hold the [ BAND ] key for 1/2 second to erase the charactors at the right.
7. When the callsign is complete, press and hold in the [ BAND ] key for 1/2 second to save
the CW ID entry and exit to normal operation.
To activate the CW Ider for use during ARTS operation:
1. Press and hold in the [ BAND ] key for 1/2 second to activate the "Menu" mode.
2. Rotate the Main Dial knob to select Menu #5 (CWID ).
3. Press the [ BAND ] key momentarily to enable changing of this Menu item.
4. Rotate the Main Dial knob to change the display to "ON."
5. Press and hold in the [ BAND ] key for 1/2 second to save the new setting and exit to
normal operation.
6. To disable the CW IDer, select "OFF" in step 4 above.
FT-7100M Operating Manual 41