Yaesu FT-7100M Operating Manual page 15

F
RONT
[ V/M ] Key: Pressing this key switches frequency control on the "main" band between
the VFO and Memory Systems. Press and hold in this key for 1/2 second to activate the
Memory Write mode.
[ HOME ] Key: Pressing this key recalls a favorite "Home" frequency memory. Press and
hold in this key for 1/2 second to activate VHF-VHF or UHF-UHF operation, as opposed
to "normal" VHF-UHF operation.
[ MHz ] Key: When this key is pressed in momentarily during VFO or Memory Tune
operation, the Main Dial knob tunes in 1 MHz steps, and if pressed and held for 1/2
second, the Main Dial knob tunes in 10 MHz steps, thus allowing quick frequency
change. When this key is pressed in momentarily during Memory operation, the Memory
Tune feature is activated, allowing offset tuning from a memorized frequency.
LCD (Liquid Crystal Display)
The display consists of segmented digits for frequency readout and various icons
representing enabled transceiver features, and it also contains information regarding
menu programming and alphanumeric names for the memory channels.
Main Dial Knob
This 24-position detented rotary switch is the main tuning dial for the transceiver. It
used for most tuning, memory selection, and function setting tasks on the FT-7100M.
Function Keys
These four keys operate in a manner similar to the Command Keys just described.
[ POWER ] Key: This is main On/Off switch for the FT-7100M.
Press and hold in this key for 1/2 second to turn to the transceiver on or off.
[ LOW ] Key: Pressing this key repeatedly allows selection of the transmit power. The
selections available are:
LOW à MID2 à MID1 à HIGH à LOW
(5 W)
[ REV ] Key: Pressing this key reverses the transmit and receive frequencies when a
repeater split is programmed. Press and hold in this key for 1/2 second to activate the
priority scan.
[ TONE ] Key: Pressing this key repeatedly allows selection of the CTCSS and DCS mode
and setting of the tone or code to be used. The selections available are:
ENC à ENC/DEC (TONE SQL) à BELL à DCS à OFF à ENC
Rotating the Main Dial knob selects the CTCSS frequency or DCS code.
FT-7100M Operating Manual
P C
ANEL
(10 W) (20 W)
ONTROLS
(35 W: UHF)
(50 W: VHF)
, S
WITCHES
• • • • • •
• • • • • •
13