Dtmf Tone Generation; A6J Only); Dtmf Autodialer Operation - Yaesu FT-7100M Operating Manual

O
PERATION
DTMF Tone Generation (MH-48
The white keys (with numbers, letters, or the Ú/# characters printed on them) on the micro-
phone may be used for manual sending of DTMF tones for autopatch or repeater control
use. Just press the PTT switch, and hold it in, while pressing the desired keys.

DTMF Autodialer Operation

Sixteen DTMF Autodialer memories are available on the FT-7100M. These DTMF Autodialer
memories can store up to 16 digits of a telephone number for repeater autopatch or other use.
To load DTMF Autodialer memories, use following procedure:
1. Press and hold the [ BAND ] key for 1/2 second to activate the "Menu" mode.
2. Rotate the Main Dial knob to select Menu # 14 (DTMFW ).
3. Press the [ BAND ] key momentarily to enable changing of this Menu item.
4. Rotate the Main Dial knob to select the DTMF Autodialer
memory channel number into which you wish store a tele-
phone number ("CH-01" ~ "CH-16").
5. Press the [ BAND ] key momentarily.
6. Use the Main Dial knob (or the microphone's [ UP ] /
[ DWN ] buttons) to select the first digits of the telephone
number you wish to store.
7. When you have selected the correct digit, press the [ LOW ]
key momentarily.
8. Now, use the Main Dial knob (or the microphone's [ UP ] /
[ DWN ] buttons) to select the second of 16 available dig-
its in the current DTMF Autodialer memory. Press the
[ LOW ] key momentarily.
9. Repeat this procedure for each digit in the telephone number.
10. If you mistake an error during programming, you may press the [ REV ] key momentarily
as a backspace key. If you wish to erase all digits before the current one, press and hold
in the [ REV ] key for 1/2 second. You may now press the [ TONE ] key momentarily to
review your entry for accuracy.
11. When entry of all digits is complete, press the [ BAND ] key. This locks the DTMF string
into the current register.
12. Use the Main Dial knob (or the microphone's [ UP ] / [ DWN ] buttons) to select another
DTMF Autodialer memory channel, and repeat the process described above, beginning
in step 4. When you are done programming all desired DTMF Autodialer memory chan-
nels, press and hold in the [ BAND ] key for 1/2 second to exit to normal operation.
28
T
RANSMISSION
only)
A6J
FT-7100M Operating Manual
DTMF Autodialer Memory
DTMF Autodialer Memory
Current Digit
Telephone Number