K&H Pet Cot House 100213618 Care Instructions

K&H Pet Cot House
Care & Instructions
Thank you for purchasing a Pet Cot House™ designed by K&H Pet Products
House™ should provide years of enjoyment and comfort for your pet. Your Pet Cot House™ is intended for use indoors and
outdoors. It provides your pet privacy and shade and comes with a one year warranty.
PET COT FRAME ASSEMBLY
1
Unroll the pet cot cover and lay it flat.
INSTALLING THE PET COT HOUSE ROOF
Parts needed to install the Roof - Your K&H Pet Cot House™ comes with 6 support rods and a roof cover
1 Connect three (3) of the rods together (Figure 1).
Then connect the remaining three (3) rods together.
Ends
Middle piece with
joints the "end"
rods slip into
3
Spread the roof cover over the top of the support rods with the
logos facing the front of the cot (Figure 3).
Optional: You can also slide the support rods through the
sleeves on the underside of the cover as shown. (Figure 4).
Figure 3
5
Smooth out and adjust the roof cover for proper fit (Figure 6).
Figure 6
™
Be sure all 4 frame tubes are threaded
2
through the sleeves sewn along edges
of the cover.
Figure 1
Figure 4
Care Instructions:
When your Pet Cot House™ is
removed from the packaging
it is safe to steam in order to
remove unwanted wrinkles. To
clean, wipe with a damp cloth.
®
. When used correctly, your Pet Cot
3
2
Insert the rods diagonally into the corner support
holes (Figure 2).
Figure 2
4
Stretch the corner elastic bands on the roof cover around the
4 legs of the cot (Figure 5).
Figure 5
Made in China
K&H Pet Products, Central Garden & Pet
Colorado Springs, CO
www.khmfg.com | (719) 591-6950
Insert all 4 frame tubes into the nylon
corner supports. Once the cot frame is
assembled, stand cot upright on its feet.
REV0_03-26- 1 8